Owner's Manual
NightRazor Light Operation:
The Levels of Light Intensity can be easily changed with the turn of a knob. Off Mode is when the knob is turned all the way back and Super Bright is when the knob is turned all the way forward. The low, medium and high levels are the clicks in between.
SOS Emergency Flash can be set by turning the knob to the Low setting, then to Medium and back to Low. This needs to be done three times rapidly. The SOS signal will then begin and you are able to switch Light Intensity Levels at that point. To end the SOS signal, all you need to do is turn the knob back to the OFF position.
Strobe Flash can be set by turning the knob to the Super Bright setting, then to High and back to Super Bright. This needs to be done three times rapidly. Once the Strobe begins, you may turn the knob to any level of brightness that you are comfortable with. Keep in mind that the Strobe Light does not work on the Low setting. To end the Strobe signal, all you need to do is turn the knob back to the OFF position.
Charging the NightRazor Light:
This unit has LED lights that will signal to you when they need to be charged. A RED FLASHING light means the unit needs to be charged. A full charge will take under 4 HOURS. It is highly recommended that this unit be fully charged before using and should be charging in between uses. A RED light on the charger shows that the unit is currently charging. A GREEN light on the charger means the unit is fully charged and ready to be used.
RED FLASHING LED- NightRazor needs to be charged
RED LIGHT ON CHARGER- NightRazor is on cradle and charging
GREEN LIGHT ON CHARGER - NightRazor is fully charged and ready to be used
The NightRazor has a charging cradle included which can be connected to the supplied 110VAC Wall Adaptor or an available 12 VDC Car Adaptor.
Safety is always important - Please do not shine this light in your eyes. These lights tend to be VERY BRIGHT.